We are a professional Toothpick processing machine manufacturer. We have a wide range of products. Our barbecue bamboo stick products are produced by Toothpick processing machine.
1, should pay great attention to avoid the production
Installation deviation.
1) The upper pressing gland should be carried out after the coupling is straightened. The bolt should be evenly supported to prevent the end face of the gland from being skewed. Check the points with a feeler gauge, the error is not more than 0.05 mm;
2) Check the fit clearance (ie concentricity) between the gland and the outer diameter of the shaft or bushing. The circumference should be uniform. Check the tolerance of each point with the feeler gauge to be no more than 0.01 mm.
2. The amount of spring compression should be carried out according to the regulations. It is not allowed to be too large or too small, and the required error is 2.00 mm. Over the assembly, the end face is pressed and the other end face is worn. Too small will cause insufficient specific pressure and will not seal.
3. After the moving ring is installed, it can be flexibly moved on the shaft. After pressing the moving ring to the spring, it should be able to bounce back automatically.
Toothpick processing machine will have many problems like this at work. What problems will it have during installation? We hope to make our products more and better, welcome you to buy our products.